S-class W202 Mercedes

1993-2000 of release

Repair and car operation

W202 Mercedes
+ 1.2. General information
+ 2. Maintenance
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
+ 8. Fuel system
+ 9. Transmission
+ 10. Running gear
+ 11. Steering
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment
- 14.2. Electroschemes
   14.2.1.1. Using electroschemes
   14.2.1.2. Reductions in electroschemes
   14.2.2. Electric equipment – a starter, the generator, the accumulator (a DB of 111 HFM/PMS)
   14.2.2.1. Key to the electric equipment scheme
   14.2.3. External lighting (DB, DD)
   14.2.3.1. Key to the scheme of external lighting
   14.2.4. Internal lighting (DB, DD)
   14.2.4.1. Key to the scheme of internal lighting
   14.2.5. Dashboard (DB of 111 HRM/PMS/of 104 HFM)
   14.2.5.1. Key to the dashboard scheme
   14.2.6. Dashboard (DD 601/604/605)
   14.2.6.1. Key to the dashboard scheme
   14.2.7. Electric equipment – a starter, the generator, the accumulator (DD 601/604/605)
   14.2.7.1. Key to the electric equipment scheme

14.2. Electroschemes

14.2.1. General information

GENERAL INFORMATION

Signaling devices, device of illumination of symbols and internal lighting: check their functioning.

Check external lighting, if necessary adjust headlights.

Check a sound signal.

Check on wear rubber brushes of screen wipers.

Stekloomyvatel: check functioning, check the provision of a nozzle, check a stekloomyvatel of headlights.

Check regulations of a tilt angle of an optical axis of headlights.

All consumers of a current: check their functioning.

Replace rubber brushes of screen wipers of a windscreen.

Rubber brushes of screen wipers of headlights: check a condition.

Clean a telescopic core of the aerial.

Check of functioning of signaling devices / external lighting

SIGNALLING DEVICES

PERFORMANCE ORDER

1. Include ignition (turn the ignition key in situation "2").

2. Light signaling devices approximately for 30 seconds and then extinguish. Check, whether all lamps according to car equipment light up.

3. The signaling device of system of laying and a tension of seat belts (an inflatable safety cushion) should go out no later than approximately in 4 seconds.

4. Include a driving beam, put in action the blinking light-signal device and check signaling devices.

EXTERNAL LIGHTING

PERFORMANCE ORDER

1. Check on damage and penetration of water of glass of signaling devices of forward and back lighting.

2. Include external lighting and check its functioning.

Check of regulation of a tilt angle of an optical axis of headlights

PERFORMANCE ORDER

1. Start the engine and leave it to idle.

2. Include a passing beam.

3. Establish in various provisions a regulator (proof-reader) of a tilt angle of an optical axis of headlights and check, whether both light bunches of headlights at the same time move.

Cleaning of a telescopic core of the aerial

Necessary fast-wearing-out details: a clearing cloth fabric to the telescopic aerial.

PERFORMANCE ORDER

1. Extend the aerial or nominate her, having included a radio receiver.

2. Clear a telescopic core a clearing cloth fabric.

3. The aerial push, or by means of switching off of the receiver force it to move automatically.

4. This operation repeat several times.

5. Then dry wipe a telescopic core a pure rag.