|
S-class W202 Mercedes1993-2000 of releaseRepair and car operation |
|
W202 Mercedes - 1.2. General information 1.3. Maintenance 1.4. Keys 1.5. Doors 1.6. Seats + 1.7. Safety systems + 1.8. Salon equipment + 1.9. Driving 1.10. Engine cowl 1.11. Ventilation block, conditioner 1.12. Some councils upon car purchase 1.13. Changed numbers 1.14. Purchase of the old car 1.15. Durability of the car 1.16. About parallelism of bridges of the car and the trailer + 1.17. Preparation of the car for winter + 2. Maintenance + 3. Engines + 4. Greasing system + 5. Cooling system + 6. Heating, ventilation + 7. Ignition system + 8. Fuel system + 9. Transmission + 10. Running gear + 11. Steering + 12. Brake system + 13. Body + 14. Electric equipment + 14.2. Electroschemes Повысить антиплагиат вуз источник. Антиплагиат вуз официальный сайт, акция читать далее. Повысить антиплагиат вуз источник. Антиплагиат вуз официальный сайт, акция читать далее. |
1.6. Seats
Change of provision of a forward seat On length: The handle (1) to lift up, a seat to move forward or back, the handle (1) to fix. Pillow inclination for sitting: To rotate a wheel (2) forward or back. Seat height: to lift a regulator (3). Sitting to move forward = to establish above. Seat to move back = to establish below. Regulator to fix. Back inclination: A wheel (4) forward or to rotate before the necessary situation back. Seat head restraint: for installation on height slightly to press them forward. To establish a head restraint so that the nape was propped up approximately at level of ears. Thus it is impossible to pull out a head restraint further the provision of an emphasis. Switches are in forward doors. Key in the steering lock in situation 1 or 2 (at an open forward door, and also at the taken-out key or the provision of a key "0"). Seat and head restraint installation: A.Izmeneniye of the provision of a pillow of a seat. V.Izmeneniye of the provision of a back of a seat. S.Izmeneniye of the provision of a head restraint. Establish a head restraint so that the nape was propped up approximately at level of ears. The head restraint can be regulated also manually forward. Prevention Input and storing of provision of a seat and head restraint: D. Input and storing button. E. Position "1" and "2" buttons. 2 provisions can be entered, after installation of a seat and a head restraint to press the button of input and storing of D, to release it and within 3 seconds to press the item button 1. By means of the item button 2 one more installation of provisions of a seat and a head restraint can be entered and kept. Call of the provisions which were stored in memory of a seat and head restraint: At emergence of need for installation of desirable provisions of a seat and a head restraint, press the corresponding item button until there will be a desirable installation. If the item button to release, for safety reasons installation process will interrupt at once. Orthopedic back of a seat For ensuring the correct position of a backbone in a back of a seat there are airbags. Situation and pressure force of a back of sitting are established at situation 2 locks of a steering. Regulate the step switch (1) pressure in airbags (from "0" = without pressure to 4 – the maximum pressure). The provision of a back of a seat are established by the switch (2) from the situation "And" – the lowest to "Е" – the highest. After the trip termination the last chosen situation is established automatically anew. Seat heating Key in the steering lock in situation 2. To include: To press 1 = a normal mode of heating. In the switch the control bulb burns To press 2 = fast heating. In the switch both control bulbs burn. After about 5 minutes heating of a seat will be switched automatically to a normal operating mode and in the switch only one control bulb will burn. To include: If in the switch one control bulb burns, to press 1. If in the switch 2 control bulbs burn to press 2. Automatic shutdown of heating of a seat will occur approximately in 30 minutes. Prevention If many consumers of energy are included or the accumulator is insufficiently charged, heating of a seat can automatically be disconnected. In this case the control bulb blinks (at fast heating both bulbs) blink. As soon as demanded tension appears again, heating of a seat joins automatically. If blinking of control bulbs disturbs, you can switch off seat heating the switch. Armrest of a forward seat Situation 1 – the armrest is lifted. Situation 2 – at the normal provision of a back of a seat. Situation 3 – at strongly inclined provision of a back of a seat. For lowering of an armrest press the button (4). Prevention Armrest of a back seat To pull out armrests for a loop. Head restraints of a back seat To establish head restraints of a back seat so that the nape was propped up approximately on lines of ears. |
|