W202 Mercedes
+ 1.2. General information
+ 2. Maintenance
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
+ 8. Fuel system
+ 9. Transmission
+ 10. Running gear
- 11. Steering
11.2. The block of an inflatable safety cushion on a steering wheel
11.3. Steering wheel
11.4. Steering trapeze
11.5. Cuffs of hinges of a steering trapeze
11.6. Power steering pump
11.7. Disorder convergence installation
11.8. Easily and easy
11.9. Maintenance of system of a steering
11.10. Diagnostics of malfunctions of system of a steering
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment
+ 14.2. Electroschemes
|
Steering draft and levers of a steering trapeze are connected with each other by means of ball hinges and do not understand.
Removal
| PERFORMANCE ORDER |
| 1. Designate paint the provision of forward wheels in relation to a nave. Thanks to it the removed wheel can be put on that place in which it was before. Release wheel bolts on the car standing on the earth, then put it on supports, unscrew bolts completely and remove forward wheels. |
|
2. Unscrew the steering shock-absorber (46) from steering draft (11). Unscrew fixing nuts of hinges of the pendular lever (26) from a soshka of the steering mechanism (23) and on rotary fists. Thus hold pins of hinges a natural an internal shestigrannik of SW 5. |
|
3. Remove hinges of a steering trapeze by means of a stripper 050 or HAZET 779. |
Prevention
Do not damage rubber cuffs.
|
|
Check
| PERFORMANCE ORDER |
1. Move hinges for pins. At the increased ease of a course or if is available люфт, replace a tip of the lever of a steering trapeze.
Prevention
The left hinge of a trapeze is intended only for turns (does not bend).
|
2. Check boots about damage and a leakage (a vystupaniye of greasing containing in them). If boots are damaged, replace a draft tip, respectively, draft since the dirt which has got inside puts out of action the hinge for a short time.
Prevention
If the cuff is damaged only at removal, it is enough to replace a cuff.
|
|
Installation
| PERFORMANCE ORDER |
| 1. Clear of greasing of a pin of hinges of a trapeze, and also seats in operating levers. |
| 2. Densely insert pins of hinges into cones of the corresponding levers. |
| 3. Wrap new самоконтрящиеся nuts, holding a pin a natural an internal shestigrannik, and tighten nuts the moment of 50 N of m. |
| 4. Screw the steering shock-absorber by means of new самоконтрящейся nuts, tightening it with the moment of 35 N of m to steering draft. |
| 5. Put forward wheels so that at removal the put marking coincided. Screw wheels. Remove the car from supports and tighten bolts of fastening of wheels with the moment of 110 N of m in a crosswise order. |
6. Check a convergence.
Prevention
For safety before the beginning of a trip be once again convinced that on all hinges of drafts are put new самоконтрящиеся nuts and they are tightened with the correct moment.
|
|
|
|
