S-class W202 Mercedes

1993-2000 of release

Repair and car operation



W202 Mercedes
+ 1.2. General information
+ 2. Maintenance
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
+ 8. Fuel system
- 9. Transmission
   + 9.1.2. Check of thickness of a disk of coupling in the mounted condition
   - 9.2. Mechanical and automatic boxes of gear shifting
      + 9.2.2. Transmission
      9.2.3. Towage of the cars equipped with the machine gun
      9.2.4. Check of level of oil in an automatic transmission
      9.2.5. Transmission oil and filter
      9.2.6. A cable of operating pressure
      9.2.7. Switching rod
      9.2.8. "Machine gun"
+ 10. Running gear
+ 11. Steering
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment
+ 14.2. Electroschemes


b47c026d b47c026d

9.2.5. Transmission oil and filter

GENERAL INFORMATION

Filling of transmission oil usually change through each 60 000 km of run of the car, at the same time also replace also the filter. At operation severe conditions (work with the trailer, mainly on short distances and movement in big cities, extremely high temperature of external air) transmission oil through each 30 000 km of run (without filter replacement) is necessary to change trips.


Prevention

Hand over the fulfilled transmission oil on special points of collecting the fulfilled oils, by no means simply do not pour out it and do not mix with household garbage.


Plums

PERFORMANCE ORDER
1. Establish the lever of a selective choice in the situation "R".
2. To Poddomkratta the car in horizontal situation.
3. If necessary remove the bottom cover of a motor compartment.
4. Establish under a transmission an oil pan (suitable capacity).
5. Unscrew in the oil pallet (3) a carving stopper of a drain opening (1) and merge oil.
6. Turn a pulley of a cranked shaft of the engine in the direction of rotation of its shaft (assistant) until the carving stopper of a drain opening on the converter of a torque will not be established over an opening of a ventilating lattice. Turn an engine shaft.
7. Turn out a carving stopper (2) drain openings and merge oil.
8. Unscrew bolts (7) oil pallets (3).
9. Unscrew bolts (6) oil filters (5), remove it down.
10. Screw the new oil filter with the moment about 4 N of m.
11. Carefully clear the oil pallet and get new consolidation.
Prevention

To cleaning apply only pure, not fleecy rags and pay attention to the most ideal purity at carrying out all working operations.


12. Evenly hardly tighten fixing bolts to the oil pallet with the moment of 8 N of m.
13. Screw in carving jams of drain openings with new sealing rings and hardly tighten them with the moment of 8 N of m.
14. Lower the car.

Filling

PERFORMANCE ORDER
1. Tighten the parking brake.
2. Open the lever of the zamkovy device and on the index of level of oil, extend the index and at the idle engine fill in 4 liters of transmission ATF oil through a pure funnel and a sieve with small cells.
3. Start the engine and leave it to work in an idling mode.
4. Add remained amount of transmission ATF oil. Check oil level by means of the index.
5. Filled quantity:
4-cylinder engine: about 5,5 l;
6-cylinder engine: about 6,0 l
6. At the standing car switch in all provisions the lever of a selective choice, thus the lever leave respectively for some seconds in separate provisions. Then again establish the lever in the situation "R".
Prevention

When switching ranges of change of the transfer relation in addition press a foot brake.


7. Insert against the stop the index of level and block it the lever of the zamkovy device.
8. Carry out a short-term trial trip, thanks to it transmission oil will get working temperature 80 ° Page.
9. Establish the car on an equal surface.
10. Check level of transmission oil at frequency of rotation of a shaft of the engine in an idling mode, if necessary, add oils.
11. Visually check tightness of carving jams of drain openings and the oil pallet.
12. Establish the bottom cover of a motor compartment.