S-class W202 Mercedes

1993-2000 of release

Repair and car operation



W202 Mercedes
+ 1.2. General information
+ 2. Maintenance
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
+ 8. Fuel system
- 9. Transmission
   + 9.1.2. Check of thickness of a disk of coupling in the mounted condition
   - 9.2. Mechanical and automatic boxes of gear shifting
      + 9.2.2. Transmission
      9.2.3. Towage of the cars equipped with the machine gun
      9.2.4. Check of level of oil in an automatic transmission
      9.2.5. Transmission oil and filter
      9.2.6. A cable of operating pressure
      9.2.7. Switching rod
      9.2.8. "Machine gun"
+ 10. Running gear
+ 11. Steering
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment
+ 14.2. Electroschemes


b47c026d b47c026d

9.2.6. A cable of operating pressure

GENERAL INFORMATION

Adjustment of a cable of operating pressure needs to be checked in the following cases, if necessary to introduce amendments:

 – surely at installation of a cable of management by gas;
 – if too strong breakthroughs at gear shifting in a range of partial loadings, i.e. are observed, at average turns of the engine. Thus do not establish too short a cable of the managing director of pressure, otherwise cannot make brake switchings.

Switching of the highest transfers is made in a range of high speeds of movement.

If switching of the highest transfers is carried out only in a range of low speeds of movement, under certain circumstances the cable can be unhooked or become torn.

Do not make any return switchings at completely squeezed out pedal of an accelerator.

Brake switchings are impossible, i.e. at return switching of the lever of a selective choice, for example, from situation "D" the transmission does not join in situation "3".


Prevention

The described claims can have and other reasons. As the assessment of malfunctions demands special experience, purposeful detection of malfunctions and their elimination charge to a repair truck.


PERFORMANCE ORDER
1. Warm up the engine to working temperature.
Prevention

Check installation of a cable of management of the gas / lever of a butterfly valve, if necessary adjust.


2. Leave to work the engine idling, disconnect from the plug the vacuum regulator equipped with the carving plug, and switch off the engine.
3. Until then roll the adjusting screw (15) while tightening the nipple on the rasporny plug (17) will not have a gap approximately in 2 mm.
4. Then unscrew the adjusting screw until the edge of an arrow will not be established precisely over a notch on the adjusting screw.