S-class W202 Mercedes

1993-2000 of release

Repair and car operation

More often than it is required, purely washed up and dried-up varnished surfaces for protection against influence of weather conditions process preserving means for creation closing a time and a water-repellent wax layer.

Immediately delete the poured fuel, oil or the greasing which has been especially poured brake liquid, differently it leads to change of coloring of a varnish covering.

Preservation repeat when the varnish any more does not push away water and it spreads on the big area. Regular preservation promotes preservation for a long time initial shine of a varnish covering.

For preservation of varnish coverings application of washing preservatives which sufficiently protect a varnish covering only gives additional possibility in case they are applied at each wash of the car, and the time interval between two sinks makes no more than two-three weeks. Apply only such varnish preservatives which contain karnaubsky or synthetic wax.

After application of detergents (a sink foam) especially it is necessary to recommend the subsequent processing with preservative application (pay attention to the instruction on application).

Polishing

Polishing of varnish coverings carry out only if the varnished covering because of insufficient leaving, under the influence of a road dust, industrial flue gases, the sun and a rain became unattractive, and shine cannot be restored by means of preservatives any more.

It is necessary to warn against application of abrasive or chemically aggressive polishing means even if the first attempt of use appeared rather successful.

Before each polishing the car should be washed purely up and dried carefully up. For the rest it is necessary to arrive according to the instruction of polishing means.

It is not necessary to process too big surfaces to avoid premature drying of polish. At application of some polishing means it is necessary to make preservation in addition. Do not make polishing on a bright sun! Do not process preservatives or polishing means matovolakirovanny details.

Removal of spots of tea

Tea spots during short time eat into a varnish covering, and they cannot be removed then completely. It is possible to remove fresh spots from tea with the soft rag moistened in washing gasoline. In urgent cases it is possible to apply gasoline from a petroldistributing column, kerosene or terpentinovy oil. Very well varnish preservative is suitable for removal of spots from tea also. After application of this means it is possible to refuse the subsequent sink.

Removal of insects

Remains of insects contain substances which can damage a varnish film if them at once not to remove. For removal it is necessary to wash away them weak tepid soap solution or detergent solution. There is also special means for removal of insects from a surface of varnish coverings.

Removal of splashes of construction materials

Splashes of construction materials wash away tepid solution of neutral detergent. Only slightly wipe, differently it is possible to scratch a varnish covering. After washing carefully rinse a surface pure water.