+ 1.2. General information
+ 2. Maintenance
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
+ 8. Fuel system
+ 9. Transmission
+ 10. Running gear
+ 11. Steering
+ 12. Brake system
+ 13. Body
- 14. Electric equipment
14.1.2. Measuring devices
14.1.3. Equipment of measurements
14.1.4. Electric equipment checks
14.1.5. Sound signal
14.1.6. Replacements of safety locks
+ 14.1.7. Storage battery
+ 14.1.8. Generator
+ 14.1.9. Starter
14.1.10. Traction relay
- 14.1.11. Lighting system
220.127.116.11. Lamps of passing, driving and antifog beam
18.104.22.168. A lamp in a forward lamp of the index of turn
22.214.171.124. A lamp in a back lamp
126.96.36.199. A lamp in a lamp of illumination of registration plate
188.8.131.52. A plafond in salon
184.108.40.206. Lamp of the index of turn
- 220.127.116.11. Headlight
18.104.22.168.1. Adjustment of headlights
22.214.171.124. Back lamp
14.1.14. Filament lamps on the dashboard
14.1.15. Light switch
14.1.16. Radio receiver
+ 14.1.17. Aerial
+ 14.1.19. Rubber brushes of screen wipers
14.1.20. Jets of a stekloomyvatel
14.1.21. Washing nozzles of headlights
14.1.22. Screen wiper and its engine
14.1.23. Protect the car
14.1.24. Anticreeping "immunodeficiency"
14.1.25. Why headlights grow dull
+ 14.2. Electroschemes
|14. The tip for a lamp of the index of turn
30. The tip for lighting
32. A hose to the device for cleaning of a rasseivatel of a headlight (a faroochistitel or a faroomyvatel)
| 33. Pneumatic pipeline
M6/2kh1, M6/3kh1. Shtekker of the screen wiper engine to the left / to the right
|22. Nut 23. Washer
24. Lever of a neck of a screen wiper
25. Protective casing
| Е1, Е2. Headlights, at the left / on the right
M6/2, M6/3. Engines of screen wipers of headlights at the left/on the right
M6/2kh1, M6/3kh1. Shtekkera of engines of screen wipers at the left / on the right
| PERFORMANCE ORDER
| 1. Remove a lamp of the index of turn.
| 2. Remove from a headlight electric wires and the pneumatic pipeline for adjustment on height.
| 3. If is available, remove the lever of a brush of a screen wiper (24) headlights. For this purpose cast away up a protective casing, unscrew a nut (22) and remove it together with a washer (23).
|4. Depending on equipment, unscrew a cross-piece or lateral protective casings in a zone of fastening of headlights.
| 5. Unscrew two screws (26) and unhook a protective casing (25) under a headlight.
|6. Unscrew screws (27-29) and carefully extend a headlight forward. Close the shock-absorber a rag not to scratch it.
|7. If is available, remove a hose to the device for cleaning of a rasseivatel of a headlight.
|8. If it is necessary to take out a rasseivatel of an optical element of a headlight, remove rubber consolidation. Take from spring clips above and below two supporting earrings (38). Remove a rasseivatel of an optical element (9) together with consolidation (21).
| PERFORMANCE ORDER
| 1. If it is removed, insert a rasseivatel of an optical element of a headlight into the case and at the same time press it until supporting earrings above and below will not be fixed with click.
| 2. In advance check consolidation on lack of porosity, if necessary replace it.
| 3. Further installation is carried out in sequence, return dismantling.
|4. After completion of assembly adjust headlights in a specialized repair truck.