S-class W202 Mercedes

1993-2000 of release

Repair and car operation

W202 Mercedes
+ 1.2. General information
+ 2. Maintenance
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
+ 8. Fuel system
+ 9. Transmission
+ 10. Running gear
+ 11. Steering
+ 12. Brake system
- 13. Body
   13.2. Forward door
   13.3. Back door
   13.4. Handle of a forward door
   13.5. Handle of a back door
   13.6. Door lock
   13.7. Internal covering of doors
   13.8. Forward window regulator
   13.9. Glass of a forward window
   13.10. Back window regulator
   13.11. Glass of a forward door
   13.12. Window regulator engine
   13.13. Perchatochny boxing
   13.14. Sheeting of the handle of gear shifting
   13.15. Forward ashtray
   13.16. Average console
   13.17. Panel of service of heating
   13.18. Internal covering of the A-rack
   13.19. Internal covering of the S-rack
   13.20. Forward seat
   13.21. Back seat
   + 13.22. Central lock
   13.23. External mirror / glass of a mirror
   13.24. A covering under the dashboard
   13.25. Front bumper
   13.26. Rear bumper
   13.27. Internal wing of the car
   13.28. Car wing
   13.29. Lattice Mercedes radiator / emblem
   13.30. Draft of a cowl of the engine
   13.31. A covering under a windscreen
   13.32. The device of supply of air for salon heating
   13.33. Catchment basin
   13.34. Paint and varnish covering
   13.35. Metal corrosion
   13.36. Automake-up
   13.37. What creaks?
   13.38. Hatch
+ 14. Electric equipment
+ 14.2. Electroschemes

13.11. Glass of a forward door

GENERAL INFORMATION

Prevention

Some instructions on work are in more detail stated in subsection 13.8., therefore we recommend to re-read this section. For a window of a back door act as appropriate.

Removal

PERFORMANCE ORDER

1. Remove an internal covering of a door.

2. Carefully remove pressurizing film in the bottom area.

Prevention

The film is easily torn.

3. Glass completely lower down.

4. Wring out up the internal sealing tire of a window from a doorframe a wide plastic wedge. Thus dispose an assembly wedge probably closer to holding clips. Clips remain on a door.

5. In the same way wring out the external sealing tire окна.17. A window slightly Raise up. Turn off in front a nut from the tire of a window regulator and disconnect the window regulator lever.

6. Take glass, rejecting forward, up from a doorway.

Installation

PERFORMANCE ORDER

1. Insert glass from above into a doorway and carefully lower down.

2. Advance glass from below up and insert into directing tire and crackers.

3. Insert the forward lever of a window regulator into the elevating tire and screw up, without tightening. The nut is tightened only after adjustment of glass of a door.

4. Insert sealing tires in front into a doorframe.

5. Adjust door glass.

6. Attach pressurizing film, having tracked, that there were no folds.

Prevention

Do not damage a film – it should provide faultless sealing.

7. Establish an internal covering of a door.