S-class W202 Mercedes

1993-2000 of release

Repair and car operation

W202 Mercedes
+ 1.2. General information
+ 2. Maintenance
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
+ 8. Fuel system
+ 9. Transmission
+ 10. Running gear
+ 11. Steering
+ 12. Brake system
- 13. Body
   13.2. Forward door
   13.3. Back door
   13.4. Handle of a forward door
   13.5. Handle of a back door
   13.6. Door lock
   13.7. Internal covering of doors
   13.8. Forward window regulator
   13.9. Glass of a forward window
   13.10. Back window regulator
   13.11. Glass of a forward door
   13.12. Window regulator engine
   13.13. Perchatochny boxing
   13.14. Sheeting of the handle of gear shifting
   13.15. Forward ashtray
   13.16. Average console
   13.17. Panel of service of heating
   13.18. Internal covering of the A-rack
   13.19. Internal covering of the S-rack
   13.20. Forward seat
   13.21. Back seat
   + 13.22. Central lock
   13.23. External mirror / glass of a mirror
   13.24. A covering under the dashboard
   13.25. Front bumper
   13.26. Rear bumper
   13.27. Internal wing of the car
   13.28. Car wing
   13.29. Lattice Mercedes radiator / emblem
   13.30. Draft of a cowl of the engine
   13.31. A covering under a windscreen
   13.32. The device of supply of air for salon heating
   13.33. Catchment basin
   13.34. Paint and varnish covering
   13.35. Metal corrosion
   13.36. Automake-up
   13.37. What creaks?
   13.38. Hatch
+ 14. Electric equipment
+ 14.2. Electroschemes

13.28. Car wing

Removal

PERFORMANCE ORDER

1. Remove a front bumper.
2. Remove lamps of indexes of turn.
3. Remove an internal wing.
	4. Remove decorative levels (moldings) hands or wring out a wide plastic shpatel.
	5. Open a door and unscrew back bolts of a wing of the car.
Prevention Thus paste over with a gluing tape a door in working area not to damage a varnish covering.
6. Unscrew a wing from below.
	7. Unscrew a wing from above (five bolts) and from below in the field of a bumper.
8. Unscrew two bolts in cut for turn indexes.
	9. Unscrew bolts on бленде lower than a headlight and remove бленду.
10. Extend a wing forward and remove it.

Installation

PERFORMANCE ORDER

1. Cover a car wing from within with enough of protective greasing for the bottom.

2. Establish and level a wing. The wing should be flush with the closed forward door or to be higher a maximum on 1 see. The gap between a wing and the closed cowl of the engine, and also a forward door should be checked.

3. Screw all bolts of fastening and smoothly tighten.

4. Once again check position of a wing of the car.

5. Preserve a cavity over an internal wing wax through cut of indexes of turn.

Prevention

Opening from above in a wing before drawing of wax to paste over with a sticky tape. After wax drawing a tape to remove.

6. Establish a bumper.

7. Establish an internal wing.

8. Mount the blinking index of turn.

9. Fix decorative levels.