|
1. Check the assembly provision of glass at its easy opening. The gap from above should be uniform, from below glass should enter into directing tire, otherwise adjust. |
| 2. Remove an internal covering of a door. |
3. Pressurizing film in the bottom area carefully remove.
Prevention
The film is easily torn.
|
| 4. Glass of a door window lower down while the bolt is in an assembly opening. Weaken a bolt, without turning off it. |
| 5. Insert from above glass into the back tire of a window, at the same time correct glass down or up, tighten a bolt. |
| 6. By means of the handle, lowering and lifting glass, check ease of its moving. |
| 7. Attach without folds pressurizing film. Attention: the film should not be damaged and should provide faultless tightness. |
| 8. Establish an internal covering of a door. |
Ручки с нанесением логотипа по материалам